FDT压电薄膜传感器

产品来源：专业加速度传感器供应商——www.aq315.com

产品说明：
FDT压电薄膜传感器:The “F” in FDT Series stands for ‘Flexible Leads’. These are rectangle elements ofpiezo film with silver ink screen printed electrodes. Rather than making the leadattachment near the sensor, the piezo polymer tail extends from the active sensor areaasflexcircuitmaterial with offset traces. This gives a very flat, flexible lead, with a connector at the end. The FDT elements are available in a variety of different sizes and thicknesses.Theyareavailable without a laminate (FDT), with a laminated (0.005” mylar) on one side (FLDT) or with tape release layer adhesive (FDT with adh) in the sensor area. The connector pinsontheFDTsensors can be directly soldered to a PCB with a reasonable level of care. This component cannot withstand high temperatures (> 80°C), and therefore coldering of the pins to a PCB must be done quickly. A heatsink clamped to the interface area between the film and the crimps will take the heat away from the film. Pre-tin the pins and then quickly solder them totheboard. Do not allow the soldering iron to touch the film, and do not use a dwelltimeofover5seconds on the pins. Low temperature solder can also be used.

所属品牌： MEAS
轴数：
输出信号： 0～5V
应用类型： 传感区与引出点需要一定距离而又不便于用导线的场合
量程（g）： -
封装： 薄膜元件
工作温度范围： 0～70℃
精确度： -
供电电源： 无源
特点： 无源，安装方便
类型： 压电薄膜传感器
电气连接： 电缆连接
资料下载：FDT压电薄膜传感器